Renovated and modernized the current 65,000 sq. ft. facility focusing on the composite industry.

Meets or exceeds the requirements of the following specifications:

• North Coast Composites Area Requirements For Composite Fabrication
  
• P.S. 20509 Area Requirements For Adhesive Bonding / Composites Fabrication
  
• P.S. 14274 Resin Transfer Molding of Composites, Fabrication and Acceptance Of
  
• 5PTPLT13 Qualification, Approval And Control of Bismaleimide Resin Transfer Molded Parts and Primary Structural Application
  
• 5PTPLT12 Qualification, Approval And Control of Epoxy Resin Transfer Molded Parts and Primary Structural Application
  
• BAC 5336 Fabrication Of Resin Transfer Molded (RTM) Fiber Reinforced Composite Parts

SPECIFICATIONS

• 1824 sq. ft.
  
• 32 ft x 57 ft x 17 ft high ceiling
  
• Acoustic drop ceiling
  
• Constant positive pressure
  
• Monitored by Dwyer / Magnehelic Differential Pressure Gage
  
• Temperature and humidity controlled
  
• Monitored by Supco Dual Set Point Temperature Alarm (beeper)
  
• Monitored by Supco THC200 Thermo-Hygrometer Clock with alarm (buzzer)
  
• Data logging via Supco Temperature & Humidity Data Logger & Software
  
• Fixed lifting capacity
  
• 5 ton Overhead beam crane
  
• 30 ft span with 12 ft lift height
  
• Manual 5 ton chain hoist

• 20,000 sq. ft. available

• 6 Oil Heaters
  
• Mokon Circulating Oil Temperature Control System
  
• Sterlco Circulating Oil Temperature Control System
  
• Dual Zone
  
• 36 kW Heating Capacity per zone
  
• 600 deg. F operating temperature
  
• Injector Systems
  
• NCTM-1000 (one unit)
  
• 1000cc capacity
  
• 300 psi injection pressure
  
• Pneumatic operated / pressure regulated
• 60 ton Crane
  

• Heated fluid reservoir
  
• Manual/visual position indication
  
• NCTM-3000 (two units)
  
• 3000cc capacity
  
• 300 psi injection pressure
  
• Pneumatic operated / pressure regulated
  
• Heated fluid reservoir
  
• Linear position control
  
• Digital panel meter w/ RS232 Serial COM port
  
• 2 Vacuum Degassing Ovens
  
• 500° F. Post Cure Oven

MACHINING OF COMPOSITE COMPONENTS
Current needs are supported by NCTM

North Coast Composites, Inc.

4605 Spring Road • Cleveland, Ohio 44131 • 216-398-8550 • Fax: 216-661-5777

This document maintained by sales@northcoastcomposites.com
Copyright © 2012 North Coast Composites,Inc.